View Full Version : Elfweave sheet
vsilvered
19-04-2010, 12:46 PM
I did one small piece elfweave sheet on Saturday using what I thought was 1.2mm copper wire and 5.0mm rings and the weave was really tight. So on Sunday, I thought I'd have another go using 5.5mm rings, only to discover that the wire that I thought was 1.2mm, was in fact 1.25mm. #-o
Anyway, using an increased AR in the second attempt resulted in a much better behaved piece of elfweave sheet :)
http://www.turquoisefruit.com/silver/elfweave_2.jpg
snow_imp
19-04-2010, 02:42 PM
Nice work there Vi.
Gemma
19-04-2010, 06:13 PM
Oooooh! Yummy!
Sheltie
19-04-2010, 08:30 PM
Going to have to try that as it is really different.
vsilvered
19-04-2010, 10:01 PM
Thanks everyone :)
Sheltie, give it a go...it's a cracking weave!
It's one of those weaves that's a bit tricky for the first few rings, but I found stabilising the rings on a piece of polystyrene with pins really helped. I used the polystyrene because it was the only thing to hand, but ideally I want to get hold of that stuff that florists use for arranging flowers which I think will last longer than the polystyrene.
Ultimately, the plan is to make a bracelet/cuff with this weave in Sterling silver using 1.2mm wire and 5mm rings.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.