View Full Version : Vallorbe piercing frame
bobbieblue
25-09-2019, 07:01 PM
Does any one else have real problems with the new Vallorbe piercing saw frame, getting the bottom nut to secure the blade? I find that when I replace a saw blade putting top nut holds but the bottom nut doesn’t. I have about 6 of these Vallorbe piercing saws in my workshop - as I run classes, and they all seem to do it! 😬 I only have this problem with the Vallorbe piercing saw frame, never with my trusty old eclipse!
Dennis
25-09-2019, 07:38 PM
Not a commonly found make in UK. It looks as if the saw blade is inserted into a hole and tightened with a knurled nut.
Maybe you can take out the offending nut and see what is preventing the blade from being fully inserted, or the nut from going fully home.
Failing a resolution, I would get a new set of frames with clamps and wing nuts and let your poor students off the hook, so to speak. Dennis.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.