Hi,
I am looking into buying the Balco microstrip to smooth and brighten castings from 3d prints.
http://balco.co.uk/wp-content/upload...Microstrip.pdf
Does any one have experience with this unit they would be willing to share ?
Thanks,
Hi,
I am looking into buying the Balco microstrip to smooth and brighten castings from 3d prints.
http://balco.co.uk/wp-content/upload...Microstrip.pdf
Does any one have experience with this unit they would be willing to share ?
Thanks,
Last edited by kreffell; 20-08-2016 at 11:05 AM.
I'd been looking at vibratory tumblers with abrasives to do the job - I'd not looked at electrostripping as an option. The current supply is outside any of my bench PSUs, so rigging a test (KNO3, perhaps?) would be slow & inconclusive.
I wonder if anyone on the 3d CAD forum is using them?
I already have the otec mini wet and dry, good for broad surfaces but not detail - happy to sell very little use.
Would be good if Balco offered samples - I would send a small ring for electro polishing.
Might be worth adding 3d section to the Cookson forum - pleased to help where I can.
Last edited by kreffell; 20-08-2016 at 04:41 PM.
Bookmarks