Hi guys,

I was casting some silver today after spending a lot of time trying to find the correct heat from torches. Finally I managed to get the silver to flow and was about to pour into a small graphite mold, when the silver exploded, and splattered everywhere, in about 100 pieces of tiny particles. Carpet is destroyed and some holes in a workbench. Luckily enough I got out of the way in time....

But now I am wondering why this happened. Has anyone experience this before.

Before i went to pour the silver from crucible to mold i was heating both at the same time with the torch.

Then tilted it into graphite mold and exploded.

any help on this would be much appreciated, as afraid to go back into studio now.....

eamon