Hello! Just a quick question, would you use a rub over setting to set a flat stone in to a bezel? Any tips are welcome!
Thanks
Hello! Just a quick question, would you use a rub over setting to set a flat stone in to a bezel? Any tips are welcome!
Thanks
Hi Mari Eluned;
The short answer is yes, but for extra retention you need a tiny bevel around the top edge if you don't have one already.
Or else for an opaque stone, a good fit and a small dab of epoxy glue at the back, before finally setting it. This also gives you a chance to show it off with a wide and possibly textured metal edge. You would be advised to cut your strip from fine silver sheet, rather than using flimsy ready cut bezel . This one below is about 0.7mm thick. Dennis.
Thank you Dennis,
Handy tips, It is Slate that I want to set, so your 2nd option would work, I like the idea of the textured edge too,
thanks for your time, Mari
Bookmarks