View Full Version : Leather cuffs
10-09-2010, 08:02 PM
Im wanting to try and make some leather cuffs and was going to make a fastening with those popper stud things but I cant find where to buy any, any ideas? or would a different fastening be better??
10-09-2010, 09:57 PM
I have thought about this from time to time, but not yet done it. Le Prevo Leather have some Sam Browne studs with rounded ends which screw onto the leather. The other end of the strap would then have a set of holes with short slits, so that they can be popped onto the stud. The bases measure 9.0 mm and the knobs 6.5, so I guess the straps would have to be at least 14mm wide. You would also need a leather punch. I could post you a few in an envelope for you to inspect if you can give me an address in my private messages.
Kind regards, Dennis.
11-09-2010, 07:47 AM
A couple of suggestions
SNAP FASTENERS our part snap Nickel plated rust free brass setting tools packs snap fasteners (http://www.handtools-uk.com/default.php?cPath=69)
Tandy Leather Factory - Snaps (http://www.tandyleatherfactory.co.uk/home/department/Hardware/Snaps/Snaps.aspx)
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.